This article provides an installation guide for metal roofing, which offers several advantages over other roofing materials such as lower energy costs and a longer lasting roof. A metal roof is more expensive compared to other materials but because it lasts longer, it may have a lower cost in the long run as the cheaper materials may need to be replaced from time to time.
Moreover, even if the cost is initially higher compared to that of other materials, it can be considered to be a good investment not only because it is a durable around the house roofing but also because it minimizes your electric bills by reflecting the heat from the sun. This is due to the air conditioner need not work so hard during the summer to keep the temperature at a comfortable level. However, it is advisable to have an installation guide for metal roofing because this kind of roofing is more difficult to dismantle and replace so that you have to install it properly the first time.
First of all, this installation guide will discuss some of the tools that you will require. These include a drill, tape measure, roofing nails, ladder, chalk line, hammer, metal snips, metal roof screws, tool belt, and wood screws. After preparing the tools and reading the instructions provided by the manufacturer on how to install the product, you will have to measure the height of the roof and add a few inches for the kind of overhang that you prefer. You will also need to measure the length of the roof to allow you to determine the quantities of the material that you would require.
Then you will have to prepare the roof by dismounting the old shingles. Because metal roofs are lightweight, you do not actually need to remove the old roof but this is advisable if you want a cleaner appearance. Anyways, it is easy to tear off the old shingles by utilizing a roofing shovel. After this, you can lay down some roof felt or tar paper to serve as the base for your roof. The next step on how to install metal roof is to place the edging that will go around the perimeter of the roof. These should be affixed using roofing nails. You will then start putting in the metal shingles, placing one sheet at a time. You may need to get the help of another person to make this process easier.
As the final step in this installation guide for metal roofing, you will put in the trim work after laying down all of the required shingles. This will cover the top peak and the edges. Do not forget to apply elastomeric roof coating, which will ensure that the assembly is watertight and that there are no leaks. Remember that if you find the metal roof to be too slippery and has a steep slope, it may be advisable to find a reliable contractor. However, you need to make sure that the contractor has the proper insurance, experience and license.